I just tried the following command, and was able to run fine:
After a power cycle the drive showed PhyConfig: 1.
- Make sure that you installed the version of Intel® Data Center Tool using the installer according to your OS version (32 or 64 bit)
- I noticed a few differences between our system and the one you are using. Your chipset is configured for IDE mode and is using the inbox Windows* driver for the chipset. The storage controller in our test system is running in AHCI (SATA) mode, and since our motherboard has an Intel Chipset, we have installed the iRST driver for Windows* 7. I will check if these differences may prevent the command from running.